Use GPS Logger as GPS Receiver

A GPS Logger serves not only as a GPS data logger that records all the GPS data on your journey but also works as a GPS receiver for many navigation software by third parties. Connect it to any PC installed with navigation software to work both together as a GPS navigation system.

 

GPS Logger with PC

  1. Slide GPS Logger onto GPS Logger Dock/ USB Cable and connect it to your PC USB port.
  2. Please go to Start-> Settings -> Control Panel -> System -> Hardware -> Device Manager -> Ports (COM & LPT), and note down the com port number of "GPS Logger USB Com Port" device.
  3. Please refer to the user manual of your navigation software to set up the transfer port and set the Baud rate between 9600 and 115200.
  4. The blue LED indicator starts to flash when the setup is completed. GPS Logger now works as GPS receiver for your navigation software.

Note: When you connect GPS Logger to the PC installed with navigation software, please select the specific COM port that GPS Logger is assigned.

 

Bluetooth GPS Logger

  1. During Bluetooth GPS Logger is turned off, long press (5 seconds) to enter pairing mode. Long press (1.5 seconds) the button to power off Bluetooth GPS Logger.
  2. The blue and red LED indicators blink in turn for 5 minutes during pairing mode.
  3. Once Bluetooth GPS Logger is successfully paired, it will not exit the pairing mode automatically. It is normal to see both the red and blue LED indicators flash continuously.
    *If necessary, enter the passcode "0000" to complete pairing.
  4. Please refer to the user manual of your navigation software for the detailed information on using Bluetooth GPS Logger as GPS receiver for your navigation software.

 

Next