GPS Logger LED Indicators

The following lists various LED indications of GPS Logger:

Main indication:

 
Power On
The blue LED indicator blinks once.

Operation: Long press (1.5 seconds) the button to power on GPS Logger.

Note: When the device is powered on and starts tracking, the blue LED indicator blinks every 4 seconds. For GPS Loggers with firmware versions older than 3.0, the blue LED indicator blinks every 16 seconds.
   
 
Data Logged
Both the red and blue indicators blink simultaneously twice.
Status: Device is powered on and GPS data has been logged successfully.
   
 
Power Off
Long press the button, and the red LED stays red until GPS Logger is powered off.
 
Memory full / Battery low
The red LED blinks: twice / once.
   
 
BT Pairing
The blue and red LED indicators blink in turn for 5 minutes during pairing mode.

Operation: While Bluetooth GPS Logger is turned off, long press (5 seconds) to enter pairing mode. (Please refer to the user manual of your handset or bluetooth device for details on bluetooth pairing.)

Note:
1. If necessary, enter the passcode " 0000 " to complete pairing.
2. Once Bluetooth GPS Logger is successfully paired, it will not exit the pairing mode automatically. It is normal to see both the red and blue LED indicators flash continuously.
3. Once Bluetooth GPS Logger is connected via bluetooth, only the blue LED indicator will flash continuously.
4. Once bluetooth connection is enabled on GT-200e, it will start logging by default.
5. If bluetooth connection fails, GT-200 Bluetooth GPS Logger will turn off automatically after 5 minutes.

 

Others:

Charging The red LED indicator stays on during charging and goes off when charging is complete.
  Status: The device is connected to power sources, such as car charger or computer USB port.
   
Push-to-log The blue LED indicator blinks once, followed by both indicators blinking simultaneously twice.
  Status: Device is powered on and functions normally.
  Operation: Press the button once to log the current GPS information.
   
Data Transfer The red LED indicator stays on, and the blue LED indicator blinks randomly.
  Status: The device is connected to PC and transferring data.
   
GPS Receiver The blue LED indicator blinks steadily.
  Status: Receiving GPS information for the connected navigation device/ software.

 

Next