Hardware & Software Settings

Please follow the instructions below to configure your GPS device with @trip PC.

Hardware Settings

On the main menu bar of @trip PC, click to configure your GPS device.

1. Configuration: By checking the option Enable password check, @trip PC will prompt you to enter a password for verification, whenever your GPS device is connected to PC prior to downloading GPS log data. Click Next to proceed with more options (continued in Step 2).
   
   Reset: If this option is selected, all current GPS log data in your GPS device will be cleared. Click Next to start clearing data, and then exit the wizard.
   


2. Select Manual Control to manually turn on/off your GPS device when needed, or select Scheduled Control to have your GPS device turned on/off automatically at a scheduled time. Click Next to continue.
   
   
   Enable LED indicator: LED indication is available on GPS Logger if enabled. It would otherwise save battery power and last for a longer tracking time if disabled.
   
   

   Note:
   1. The GPS device must have been successfully positioned prior to using Scheduled Control.
   2. The device startup can only be scheduled twice in one day.

3. Set up tracking interval for your travel data logger at this page. Click Next to continue.
   

   
   
   Circular Logging: When this option is enabled, the GPS logger will keep on recording trips even if the memory has reached its limits. When the memory is full, the oldest records will be overwritten as the GPS logger records on. (This feature is available in firmware version 3.05 and up.)
   
   Enable button control: Button control is available on GPS Logger if enabled. It would otherwise prevent you from any unwanted action if disabled.
   
   Motion Detection: When enabled, the GPS Logger will switch on automatically upon detection of motion. (This feature is only available with i-gotU GT-600.)
   
   Advanced: More advanced option(s) are available for selection. (This option is only available with i-gotU GT-200e and GT-600.)
   - GT-200e: Start tracking when Bluetooth enabled.
   - GT-600: Auto power on upon charging (only if manual control is seleted).

   
   
4. Hardware configuration will be complete after the Setting Wizard finishes writing configuration to the GPS device.
   

   

Software Settings

On the main menu bar of @trip PC, click to configure @trip PC.

1. Update Reminder: Select this option to determine how often you would like to check the latest updates about @trip PC program.
2. Measurement: Select either Imperial or Metric as your measurement unit for GPS logging.
3. Google Maps API Key: In order to share your Travel Blog on the web page, an API key is required. Click Obtain key from Google to get an API key from Google.
   
   

Next